Download Print this page

infobit iTrans DX-TR-22 Quick Manual

Advertisement

Quick Links

iTrans DX-TR-22
QUICK GUIDE
Thanks for choosing INFOBIT iTrans DX-TR-22, this guide will
take you to know how to use this product! This product
provides analog input/output conversion with the Dante
channel and requires a PoE network power supply.
1. INTRODUCTION
This product supports two sets of balanced I/O analog signal
access to the Dante system through a local network. With
combo XLR input interfaces. Provides the function of the
phantom power and the input signal gain adjustment.
The output interface is a standard three-pin XLR socket,
with analog signal output balance. The four output versions
can be selected. Please use CAT5 or above to connect the
PoE switch.
2. FUNCTION
For analog signal and Dante signal conversion.
Support 2 channel analog inputs, 2 channel analog
outputs.
Support 2 channel Dante inputs, 2 channel Dante
outputs.
The input channel has a phantom power switch and a
gain manual adjustment knob.
PoE power supply, 802.3af, 802.3at standard PoE
switch.
3. INSTALLATION
Suggestion: We recommend that you use the standard type
120 wall box we provide for your installation.
3.1 Insert the wall box into the wall, then use the
screwdriver to remove the two screws in the middle of the
panel and take the down panel.
3.2 Connect the cable, insert the mainframe into the wall
box, and tighten the screw.
3.3 Cover panel, tighten the screws.
47mm
78mm
85mm
95mm
Behind
3.4 PWR indicator indicates the state of the power supply.
3.5 Download Dante Controller routing control software for
routing configuration. Other management software that
supports Dante matrix mixing can also be configured.
3.6 The front face of the panel is shown below.
The phantom switch uses a hidden self-locking button
switch. When the switch is pressed, the button lights up,
and the Phantom power is turned on. Otherwise, the light
goes out, and the Phantom power is closed.
The gain adjustment knob is hidden in the adjustment
hole, and the input gain value of the corresponding
channel is adjusted by the attached screwdriver. The gain
INFOBIT AV
52mm
45mm
Side
iTrans DX-TR-22

Advertisement

loading

Summary of Contents for infobit iTrans DX-TR-22

  • Page 1 DX-TR-22 47mm 45mm QUICK GUIDE Thanks for choosing INFOBIT iTrans DX-TR-22, this guide will take you to know how to use this product! This product 78mm provides analog input/output conversion with the Dante channel and requires a PoE network power supply.
  • Page 2 Warranty regulations: to the switch, whether Link light and data light flicker. The warranty period for this product is 2 years. C: Equipment damage, contact INFOBIT to get technical The product performance failure caused by non-human support. damage during the warranty period can be repaired free of charge.