infobit iTrans DX-T-22 Quick Manual

iTrans DX-T-22
Quick Guide
1. Product Introduction
This product is applied to the audio system field to convert
the analog audio signal to Dante audio signal. Power
supply Ethernet (PoE) switch.
2. Product Feature
1. Function Introduction: Convert the received analog
audio signals to Dante network audio signals.
2. Input & Output : Support two analog audio signal
inputs, two Dante outputs.
3. Hardware interface type: Two XLR are used to input
analog audio signals; One RJ45 port is used to output
Dante network audio signal.
4. Technical Parameters
Model No.
Product Type
Function
3 pin XLR F/M
RJ45 Port
Analog audio interface
Dante
Frequency response
Maximum signal level
(balanced)
Dynamic range
SNR (Signal to Noise Ratio)
THD (Total Harmonic Distortion)
iTrans DX-T-22
Audio signal adapter
Convert analog audio signal to
Dante network audio signal
output
2
1
XLR
RJ45
20Hz to 20kHz (-/+0.5dB)
+18dBu / +4dBu / 0dBu
> 100dB
> 100dB
< 0.01%（+4dBu）
Power consumption
Operating temperature
Size (LxWxH)
Weight
4. Product Overview
5. Product Connect
1. Download and install the Dante Controller from
Audinate website (www.audinate.com
2. Connect the device to the switch using Dante network
audio system with network cable.
3. The analog audio transmission device is connected
through the XLR interface.
4. Search for devices in Dante Controller software, Select
and open the devices to be configured. On the Routing
page, match the input row with the output column with
a custom check.
Once set up and configured the audio routing between
5.
audio device, the audio device will remember and save
the settings.
6. Do not spill any corrosive chemicals or liquids on or
near the equipment.
<1W
0-40℃
652mm x 32mm x 22mm
0.2kg
).