Cannot Scan Films; Thumbnail Display Does Not Display Correctly After Previewing; Cannot Obtain A Clean Scan, Colors Scan Incorrectly; Image Becomes Too Dark Or Too Bright When Cropping Frame Is Moved, Expanded Or Contracted - Canon PIXMA MP800 User Manual

Cannot Scan Films

Cause
ScanGear MP and MP Navigator
settings are not set for scanning
film.
Resolution setting is too high and
scanning is slow.

Thumbnail Display does not display correctly after previewing

Cause
You are attempting to scan film with
extremely dark or bright contents./
The spaces between frames are
extremely narrow (0.08" / 2 mm is
standard).

Cannot obtain a clean scan, colors scan incorrectly

Cause
Film condition is poor due to faded
colors.
Image becomes too dark or too bright when cropping frame is moved,
expanded or contracted
Cause
Changing the size or position of the
cropping frame selects
inappropriate color data.
138 Troubleshooting
When scanning in the Simple Mode in ScanGear MP, select [Negative
Film (Color)] or [Positive Film (Color)] in the [Select Source] category.
When scanning in the Advanced Mode in ScanGear MP, select [Color
Negative Film], [Color Positive Film], [Monochrome Negative Film],
[Monochrome Positive Film] in the [Select Source] category.
When scanning on the MP Navigator, scan using [Scan Film].
If the Output Resolution is set to too high, scanning takes a long time or
the computer seems to be freezing. If this happens, lower the Output
Resolution and rescan.
If thumbnails are not displayed properly after previewing with ScanGear
MP, scan in the Advanced Mode. For more information, refer to the Scan
Guide.
In the ScanGear MP's Advanced Mode/Image Settings, correct the image
using the [Fading Correction] and [Grain Correction] functions.
Note
* If a print out of an image does not appear satisfactory or the same as
what you see on the monitor, you may need to change the print settings,
or the machine itself may have engaged in problems. See
Come Out/Printing is Blurred/Colors are Wrong/White Streaks/Straight
Lines are Misaligned/Cannot Print to End of Job" on page
Perform the following procedures in Advanced Mode in ScanGear MP.
1. Click [Preview] to rescan the preview image.
2. Confirm that the display mode is set to [Thumbnail Display].
If the display mode is set to Thumbnail Display Off, click [Thumbnail] to
change to Thumbnail Display On.
3. In the [Apply the tone value to all frames] section, click [Apply].
4. Adjust the cropping frame.
5. Click [Scan].
Action
Action
Action
Action
"Ink Does Not
117.
Chapter 12