Canon PIXMA MP800 User Manual page 17

(25) Power Connector
This is the connector used to connect the provided power cord.
(26) Rear Cover
Open when clearing jammed paper.
(27) USB Connector (for computer)
This is the connector used to connect the machine to a computer using a USB cable.
Important
Note
Operation Panel Name and Functions
(1) (2)
(3) (4) (5)
(10) (11)(12) (13) (14)
(1) [ON/OFF]
Turns the machine ON and OFF. Before turning ON the machine, make sure the
Document Cover is closed.
(2) [COPY]
Switches the machine to Copy mode. Flashes when the machine is turned on.
(3) [SCAN]
Switches the machine to Scan mode. This button is used when the machine is connected
to a computer. (Refer to the Scan Guide.)
(4) [PHOTO/FILM]
Switches the machine to Photo/film mode.
(5) [MEMORY CARD]
Switches the machine to Memory card mode.
Chapter 1
While the machine is printing from or scanning images to the computer, or
the computer is in the sleep mode or standby mode, do not disconnect
and connect the USB cable.
For information on how to install the Print Head and ink tanks, refer to
the Easy Setup Instructions.
Ink Tank Lamps
You can check the status of each ink tank according to the way its
lamp flashes.
On: The machine is ready to print.
Slow flashing (about three seconds): Ink is low. Prepare a new ink
tank. For details, see
Fast flashing (about one second): Ink tank is empty, or the machine is
not ready due to an error.
Off: Make sure all the ink tanks are installed properly. If an Ink Tank
Lamp remains unlit even after reinstalling ink tanks, an error has
occurred and the machine is not ready to print.
(6)
(15)
"Getting the Ink Level Information" on page
(7)
(16) (17)(18)(19)(20)(21)
Before Printing
95.
(9)
(8)
15