Turning The Machine On And Off - Canon PIXMA MP800 User Manual

Turning the Machine ON and OFF

Turn on the machine before starting printing.
Turning on the Machine
Before turning on the machine, confirm that the Print Head and ink tanks are set into place.
Note
1
Press [ON/OFF].
[COPY] flashes green for a while, and then turns on.
Note
Turning off the Machine
1
To turn off the machine, press [ON/OFF].
The machine is off when the currently selected Mode button (e.g. COPY) stops flashing and
all Operation Panel lamps are off.
Important
Setting the Power Save Mode
The machine is equipped with a Power save mode. In the Power save mode, the internal
fluorescent lamp are turned off, and the selected Mode Lamp stays lit. You can configure the
interval that the machine waits before entering Power save mode. See
on page 94.
When you try to copy or scan, the machine will exit from Power save mode.
If you use the machine frequently, we recommend that you set the Power save transfer time
to 1 hour or 8 hours.
The Screen-saver Mode
The LCD goes out if the machine is not operated for 5 minutes. Press any button to restore
the display. You cannot change the period before the LCD goes out.
Chapter 1
If preparatory operations above are not yet finished, follow the Easy
Setup Instructions to complete them.
If the Alarm Lamp lights orange and an error message is displayed on the
LCD, see "An Error Message is Displayed on the LCD" on page
When removing the power plug after turning off the machine, be sure to
check that all the lamps on the Operation Panel are not lit. If the power
plug is removed from the wall outlet with the lamps on the Operation
Panel lit or blinking, the machine cannot protect its Print Head and may
be unable to print.
See "Keeping the Best Printing Results" on page
113.
100.
"Power save setting"
Before Printing 17