Patton electronics SmartNode 4400 Quick Start Manual page 4

SmartNode 4400 Quick Start Guide
Introduction
This Quick Start Guide leads you through the basic steps to set up a new SmartNode (see figure 1) and to
download a configuration. Please note that this guide does not replace the detailed Software Configuration
Guide and the Getting Started Guide on the CD-ROM and available online at www.patton.com/voip.
Figure 1. SmartNode 4400
SmartNodes can be used for a wide variety of IP and voice over IP applications. To support and ease the config-
uration of the SmartNodes, configuration templates for the most important applications are available online at
http://www.patton.com/voip/appnotes.shtml.
Setting up a new SmartNode consists of the following steps:
1. Connect a PC to the SmartNode, log in and configure your LAN IP address (see page 5 for details)
2. Connect the SmartNode to the LAN (see page 7)
3. Download a configuration example, adapt it to your network, and load it onto the SmartNode (see page 8)
Introduction 4