Dsw2 - Hitachi YUTAKI M R32 Series Installation & Operation Manual


NOTE
• This operation is reset once the compressor is in Thermo-ON mode.
• During the test run operation the units will operate continuously during 2 hours without Thermo-
OFF and the 3-minute guard for compressor protection will be effective.
• Test run will start within 20 seconds after setting DSW1 pin 1 to ON position.

6.2.1.2 DSW2

◆ Optional Function setting
RASM-(2/3)VRE: PCB1
RASM-(4-6)VR(W)1E: PCB2
RASM-(4-7)R(W)1E: PCB1
DSW2
Factory setting
Function selection setting mode
External input, output setting mode
◆ Not used
RASM-(4-7)R(W)1E: PCB2
DSW2
Factory setting
PMML0600 rev.0 - 06/2022
RASM-(2/3)VRE RASM-(4-7)(V)R(W)1E
1 2 3 4 5 6 1 2
1 2 3 4 6 1 2
5
1 2 3 4 5 6 1 2
RASM-(4-7)R(W)1E
1
3 4 5 6
6
3 4 6
5
3 4 5 6
2 3 4
84