Thermo Scientific 3490M Manual page 35

Section 6
Programmable Models
Setting the Segment Type
(continued)
6-12 Clean Room Oven
cALL (Running Multiple Programs; 4x16 Segment Programmable
Models Only)
To call a program as a subroutine:
If you want to run multiple programs, you can program the controller to
"call" or link one program to another. This makes it possible to run one
program at any time during another program and also return to the
original program if desired.
1. Press the PAGE button until you reach the program list (ProG LiSt).
2. Press the SCROLL button until display reads, "tYPE."
3. Press the UP or DOWN button until display reads, "cALL."
4. Press the SCROLL button until display reads, "PrG.n."
5. Press the UP or DOWN button to select a program number to be
linked.
6. Press the SCROLL button until display reads, "CYC.n."
7. Press the UP or DOWN button to select the number of cycles the
linked program is to be run.
End
To end or repeat a program:
1. Press the PAGE button until you reach the program list (ProG LiSt).
2. Press the SCROLL button until display reads, "tYPE."
3. Press the UP or DOWN button until display reads, "End."
4. Press the SCROLL button until display reads, "End.t."
5. Press the UP or DOWN button to toggle between "dwEll" (an
indefinite dwell), "S OP" (End Segment Output Power) and "rSET"
(reset).
Thermo Scientific