Mitsubishi Electric MR-J5-B User Manual page 38

Test operation select switch (SW3-1)
When the test operation mode is selected with the test operation select switch (SW3-1), the SSCNET III/H
communication for the servo amplifier and later shuts off.
Turning "ON (up)" the test operation select switch enables the test operation mode. In the test operation mode, functions such
as JOG operation, positioning operation, and machine analyzer are available using MR Configurator2.
Page 54 Test operation
Disabling control axis switches (SW3-2, SW3-3, and SW3-4)
Turning "ON (up)" the disabling control axis switch disables the corresponding servo motor. The servo motor will become in
the disabled-axis state and will not be recognized by the controller.
Disable the switches in order from the rear axis. Disabling the front axis only will trigger [AL. 011 Switch setting error]. The
following table shows an example of setting a 2-axis servo amplifier.
Disabling control axis switches of
A-axis (SW3-2)
OFF
OFF
ON
ON
Rotary switches (SW1/SW2)
Set the same controller axis No. for the rotary switches (SW1/SW2) and the controller. The number of axes that can be set
depends on the controller.
With the rotary switch (SW1/SW2) settings, the servo control axis No. can be set from 1 to 64. Setting the control axis No. to
65 or greater will trigger [AL. 011 Switch setting error].
■1-axis servo amplifier
Rotary switch settings
SW1
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
1
1
1
1
1
1
3 STRUCTURE
36
3.2 Switch setting and display of the servo amplifier
Disabling control axis switches of
B-axis (SW3-3)
OFF
ON
OFF
ON
Control axis No.
SW2
0 1-axis
1 2-axis
2 3-axis
3 4-axis
4 5-axis
5 6-axis
6 7-axis
7 8-axis
8 9-axis
9 10-axis
A 11-axis
B 12-axis
C 13-axis
D 14-axis
E 15-axis
F 16-axis
0 17-axis
1 18-axis
2 19-axis
3 20-axis
4 21-axis
5 22-axis
A-axis
Enabled
Enabled
[AL. 011 Switch setting error] will occur.
B-axis
Enabled
Disabled