Kia Sorento 4wd 2011 Workshop Manual page 1866

Kia Sorento 4wd Workshop Manual (V6-3.5L (2011))
Kia Workshop Manuals > Starting and Charging > Power and Ground Distribution > Auxiliary Power Outlet > Component
Information > Diagrams > Diagram Information and Instructions > Page 2212
Circuits which include any solid-state devices should be tested only with a 10-megaohm or higher
impedance digital multimeter. When measuring resistance with a digital multimeter, the battery
negative terminal should be disconnected. Otherwise, there may be incorrect readings. Diodes and
solid-state devices in a circuit can make an ohmmeter give a false reading. To find out if a
component is affecting a measurement, take one reading, reverse the leads and take a second
reading. If different the solid-state device is affecting the measurement.
JUMPER WIRE WITH FUSE
Use a jumper wire with a fuse to by-pass an open circuit.