Table of Contents
Advertisement
a) Connect the battery terminal to rear of alternator and tighten to 11 lbs. ft. (14 Nm).
b) Connect the electrical connector to rear of alternator
c) Clip wire harness retainer into bracket
d) Install the idler pulley and tighten to 39-42 lbs. ft. (53-57 Nm).
e) Install the serpentine belt as shown with correct routing.
f) Lower the engine and install the front engine mounting plate, tighten bolts to 47-61 lbs. ft. (63-83
Nm).
g) Install the Power steering hose bracket and tighten bolt to 11 lbs. ft. (14 Nm).
h) Install the engine air intake duct and connect battery cable.
i) Raise the vehicle and connect A/C compressor electrical connector.
j) Install the front roll-stopper retaining bolts, tighten to 36-47 lbs. ft. (49-63 Nm).
k) Install the front splash shield and lower the vehicle.
I) Reprogram customer pre-set stations and set the clock to the correct time.
AFFECTED PRODUCTION RANGE
REQUIRED PARTS
Advertisement
Table of Contents
