3.
Names and Functions of Parts
The names and functions of the DR-7090C parts are shown below.
Feeder
a Feeder Cover
Open this cover to clear document jams and clean the
rollers.
(See p. 3-22 and p. 5-6.)
b Opening Lever
Operate this release lever when opening or closing the
feeder cover.
c Document Set Indicator
This indicator lights when there is a document in the
document feeder tray.
(See p. 3-4.)
occurs, this indicator flashes.
d Slide Guide
Adjust this guide to the marking on the document size
label that indicates the applicable document size.
p. 3-4.)
e Document Feeder Tray
Load documents to be scanned here.
f Document Eject Tray
Scanned documents are ejected here. Open the document
feeder tray to remove ejected documents.
g Eject Tray Extension
h Operation Panel
(See p. 1-12.)
When a paper jam
(See p. 3-22.)
(See
(See p. 3-4.)
(See p. 3-5.)
1-11
Chapter 1 Before You Start Using the Scanner
Flatbed
a Pressure Board (Black)
This board presses the document page against the glass
during scanning.
(See p. 3-5.)
b Flatbed (Platen Glass)
When placing the document onto the platen glass, align it
with the arrow in the upper left corner of the glass.
p. 3-5.)
c Scanning Area Cleaning Tool
Use this when cleaning the scanning area inside the feeder.
(See p. 5-9.)
d Opening Sensor
This sensor detects whether the feeder is open or closed.
(See p. 3-5.)
e Air Vents
f Securing Brace
The securing braces prevent the scanner from tipping
backward when the feeder is open.
g Power Switch
(See p. 2-9.)
(See
(See p. 1-3.)