Other Settings Dialog Box - Canon imageFORMULA DR-7090C User Manual

Hint
Gamma table data (*.pxg files) consists of 258 lines of text used
to create the desired image data. Refer to "Gamma Table Files"
in the ISIS/TWAIN driver Help for details.
Buttons
[OK] button
Click this button to accept changes and close the Basic
Setup dialog box.
[Cancel] button
Click this button to reject changes and close the dialog
box.
[Help] button
Click this button to display help for this dialog box.

Other Settings Dialog Box

This dialog box appears when you click the [Others] button in
the Advanced Settings dialog box.
This dialog box allows you to make settings for the feed
method, stamps, and prescan.
The items you can set differ depending on the application
program you use. Make the settings as needed for the screen
actually displayed.
■ Types of Other Settings Dialog Box
There are the following types of Other Settings dialog box.
Other Settings Dialog Box (ISIS Driver)
This dialog box is displayed for ISIS-compatible
application programs (CapturePerfect, etc.).
Chapter 8 ISIS/TWAIN Driver Settings
Other Settings Dialog Box (TWAIN Driver)
This dialog box is displayed for TWAIN-compatible
application programs (Job Registration Tool).
Hint
In the case of both ISIS and TWAIN, the [Stamp] check box only
appears when an optional stamp unit is installed.
■ Settings of Other Settings Dialog Box
You can configure the following settings in the Other
Settings dialog box.
Feeding Option
Select the feeding method for documents.
[Standard Feeding]
If scanning is started from an application program, the
document loaded in the feeder or on the flatbed is scanned.
Scanning ends when all pages of the document have been
fed.
[Panel Feeding]
If scanning is started from an application program, the
document loaded in the feeder or on the flatbed is scanned.
After that, you can continue scanning documents by
loading a new document in the feeder or on the flatbed and
then pressing the Start key on the scanner. To finish
scanning, press the Stop key on the scanner or stop
scanning from the application program.
8-16