Service Position - Panasonic SC-EN38GCS Service Manual

11 Service Position

Note : For description of the disassembly procedures, see the section 9
11.1. Checking & Repairing
Transformer & AC Inlet P.C.B
Step 1 : Remove Rear Panel.
Step 2 : Remove Fan Unit, Transformer & AC Inlet P.C.B..
Step 3 : Connect 4P cable at the connector (CN601) on Main
P.C.B..
Step 4 : Connect 2P cable at the connector (CN600) on
Transformer P.C.B..
Step 5 : Check & repair AC Inlet & Transformer P.C.B.
according to the diagram shown.
11.2. Checking & Repairing Detector
P.C.B
Step 1 : Remove Rear Panel.
Step 2 : Remove Fan Unit & Transformer P.C.B..
Step 3 : Connect 4P cable at the connector (CN601) on Main
P.C.B..
Step 4 : Connect 2P cable at the connector (CN600) on
Transformer P.C.B..
Step 5 : Detector P.C.B. can be checked at its original position.
47
SC-EN38GCS