Table of Contents
Advertisement
Kaden Installer's Manual
Ducted Gas Heaters
9. COMMISSIONING KUN4 & KUN5
All Kaden heaters have been factory tested, but should be commissioned and adjusted in accordance with the
following instructions to ensure efficient and optimal heating performance.
Remember:
•
Switch the mains power OFF before touching any wiring.
•
All these steps must be carried out by a qualified trades person.
•
If the heater cannot be adjusted to operate in accordance with these instructions, then contact:
1300 4KADEN (1300 452 336)
9.1
HEATER CONTROL SETTINGS
The NG-3 controller requires a Networker to access and modify installation parameters.
KUN4 / 5
NG-3 Controller
32
For technical support please call.
Control Board
Diagram 21
Defaults
Clear
Defaults – Reset all parameters to default values.
Clear – Clear fault conditions and system reboot.
Advertisement
Table of Contents
