Installation; Area To Cut Out In Wall; Installation Of Flashing - Kaden KEX Series Installer Manual

Kaden Installer's Manual
Ducted Gas Heaters
4.3

INSTALLATION

4.3.1 Area to Cut Out in Wall

When installing the heater at ground level,
create one rectangular hole to suit the total
POP width and height, all the way to ground
level, (refer to Diagram 15)
Refer to the Base Box for required
wall cut out dimensions.
NOTE

4.3.2 Installation of Flashing

Flashing MUST BE fitted to ensure the ductwork is adequately weather protected.
Step 1. Fit side flashing using existing screws on
cabinet sides.
Step 3. Sit top flashing on top of side flashing
edges. Once in place silicone along the
upstanding face of top flashing.
22
Wall cut-out areas
Base Box
Level concrete base
Ground level
Step 2. Slide top flashing under flashing rail on
Silcone
Step 4. Push the heater up against the wall and
Diagram 15
base box
secure side flashing to the wall.