Axminster Workshop AW355WL Original Instructions Manual page 6

ASSEMBLY
3. Inset the tool rest (B) into the machined hole on the banjo
arm and secure using the lift and shift handle lock, see fig 06.
Fig 06
B
4. Place all accessories into one of the two tool holders,
see fig 07-08.
Fig 07-08
Tool holder/carrying handle
5. Locate the power cable and insert the connector into the
three pinned socket to the side of the control box, see fig 09.
6. Place the lathe on a work bench and adjust the four
feet until level.
Optional Accessories (see page 14)
Please contact our Customer Service Department for further
details or visit our website at axminster.co.uk.
Floor stand assembly
6
Fig 09