Table of Contents
Advertisement
5. Degauss the CRT face.
6. Connect the photo sensors of the Colour Analyser to the CRT.
Note:
CRT cut off adjustment is completed.
Adjustment procedure
1. Adjustment of Low Light
Adjustment SUB BRIGHT, so that "Y" axis indicates 6.5
Adjustment R-CUT OFF, so that y axis indicates 0.248.
Adjustment B-CUT OFF, so that x axis indicates 0.247
2. Adjustment of High Light
Adjust SUB BRIGHT, so that "Y" axis indicates 150.
Adjust R-DRIVE, so that y axis indicates 0.264.
Adjust B-DRIVE, so that x axis indicates 0.258.
5.11. FOCUS
Item / preparation
1. Receive a cross-hatch pattern signal.
Adjustment procedure
1. Adjust the Focus to thin all the Lines by Focus 1 Control.
(Prefer to thin the Vertical Lines than Horizontal Line.)
2. Adjust the Focus to thin the Horizontal Lines by Focus 2 Control.
22
Advertisement
Table of Contents
