A. Set DY to CRT not to tilt up and down and left and right deflection.
(Fig. 1)
B. Set CY to CRT and set CY magnet primarily. / Pur Mg: Set Pur Mg
that 2 magnets are vertical position. / VRS Mg: Set VRS Mg that 2
magnets are side position.
C. Set geomagnetic correction DAC [0].
2. ADJUSTMENT
A. Receive the white balance pattern.
B. Adjust V-CENTER.
C. Set R,B CUT OFF to minimum (0) and set G CUT OFF to center (511).
D. Receive the aging pattern.
E. Set 2 magnets of vertical position to up and down equally so that
center part of CRT. (Fig. 3)
16