CONTENTS SAFETY PRECAUTIONS ................................. 2 SERVICE HINTS ..................................3 VOLTAGE CHECK AND OPTION BYTES ........................... 4 WAVEFORM PATTERN TABLE............................... 5 ALIGNMENT SETTINGS ................................6 BLOCK DIAGRAMS.................................. 7 PARTS LOCATION................................... 9 REPLACEMENT PARTS LIST..............................10 SCHEMATIC DIAGRAMS............................... CONDUCTOR VIEWS ................................SAFETY PRECAUTION GENERAL GUIDE LINES It is advisable to insert an isolation transformer in the Check each exposed metallic part and check the...
VOLTAGE CHECK 2094.0108* test conditions ; MAIN B+ Voltage [V] 131,3 Input voltage : 230VAC 12V [V] 11,95 TV set on ON mode (if nothing specified) Picture : colour bar - Dynamic STAND BY [V] 12,1 Sound : 1Khz - (mode : Music) SOUND B+ [V] 12,4 *Volume Min.
ALIGNMENT SETTINGS (The figures below are nominal and used for representative purposes only.) To access Service Mode select program position 99 and set sharpness to minimum. Press “MUTE” button on remote control and at the same time press the "V" button on the customer controls at the front of the TV, this will place the TV set into Service Mode.
REPLACEMENT PARTS LIST Important Safety Notice Components Identified by mark have special characteristics important for safety. * When replacing any of these components, use only manufacturers specified parts. In case of ordering these spare parts, please always add the complete Model-Type number to your order.
SCHEMATIC DIAGRAMS FOR MODELS TX-29PM1D, TX-29PM1F, TX-29PM1P (CP-521F CHASSIS) IMPORTANT SAFETY NOTICE Components identified by mark have special characteristics important for safety. When replacing any of these components, use only manufacturers' specified parts. NOTE RESISTOR All resistors are carbon ¼W resistor, unless marked otherwise.