Bowflex Max Total 16/40 Service Manual page 107

1. Unplug the AC Adapter from the wall outlet and machine.
2. Using a 5mm hex wrench, remove the indicated hardware from the Left
Upper Handlebar and place it out of the work area.
Note: Be aware that the Upper Handlebar must be supported when
removing the hardware.
3. Place a rag or protective material below the Connector Arm to protect
the Shroud from potential scratches from the Connector Arm.
4. Using a 6mm hex wrench, remove the indicated hardware (by oval) that
connects the Connector Arm and the Handlebar Pivot Assembly.
Note: The Connector Arm will pivot downward if not lowered slowly onto
the rag protecting the Shroud.
5. Using a 6mm hex wrench, remove the indicated hardware (by arrow)
that connects the Handlebar Pivot Assembly to the Console Mast.
6. Slide the Handlebar Pivot Assembly off of the Console Mast and
replace with the new assembly.
7. Installation is the reverse procedure.
8. Repeat Steps 2 - 7 on the right side of the machine.
9. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
Left Upper
Handlebar
Pivot Arm
107
Connector Arm