Elan EL-SC-300-ZW Quick Install Manual

Elan EL-SC-300-ZW Quick Install Manual

System controller

Advertisement

Quick Links

Quick Install Guide
EL-SC-300
System Controller

Advertisement

Table of Contents
loading

Summary of Contents for Elan EL-SC-300-ZW

  • Page 1 Quick Install Guide EL-SC-300 System Controller...
  • Page 2 QUICK INSTALL GUIDE IMPORTANT SAFETY INSTRUCTIONS Read, understand and follow ALL safety and installation instructions included in this manual. Failure to follow the included documentation may damage the product and will void manufacturer’s warranty. Follow ALL installation guidelines included with the product. Installation of the product in high humidity environments, in close proximity to heat sources and /or non-recommended locations will impede, interfere and/or damage the intended operation of the product.
  • Page 3 All mains operated nodes within the network will act as repeaters of vendor to increase reliability of the network. In an Elan SC Series System Controller, the host application controls the device reset feature. If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude or re-include all of the nodes in the network.
  • Page 4: Table Of Contents

    QUICK INSTALL GUIDE Contents 1. Front Panel..........5 2.
  • Page 5: Front Panel

    EL-SC-300 The ELAN Training Guide contains valuable hardware and software reference documentation and is considered an important supplement to this document. Make sure you have the latest version by visiting the ELAN Dealer website at www.elancontrolsystems.com and follow the Dealer Resources link.
  • Page 6: Mounting

    The table shows the 568A and 568B color codes and the function of each conductor of the RS-232 ports. Please refer to the ELAN Integration Note for the specific device to determine the proper RJ45 to DB9 adapter to use.
  • Page 7: Rs-485 Serial Connections

    Or use the voltage detector to sense when a standard doorbell chime is rung to trigger an ELAN doorbell chime through an audio system. NOTE: DO NOT WIRE DIRECTLY TO THE DOORBELL BUTTON, THIS WILL DAMAGE THE EL-SC-300.
  • Page 8: Relay Connections

    QUICK INSTALL GUIDE 8. Relay Connections Six normally open relays are available for controlling third party devices - motorized lifts, window shades, and projection screens. The included removable connectors will accept up to 16ga bare copper leads. Be careful to verify that no portion of one wire touches the other wire. Prior to connection verify that the connected load does not exceed 24volts AC/DC or 1amp.
  • Page 9: Network Connection

    • Power (1) Coaxial Type A, 2.5mm inside diameter. 12V 2.5A • 2.4 / 5 GHz WiFi 802.11 b/g/n/ac System Software compatibility: Refer to the integration note for compatibility Updates managed by ELAN Core Module software General Operating Temperature: 0° to 40° C Operating Humidity: 90% Maximum (Non-Condensing)
  • Page 10: Notes

    QUICK INSTALL GUIDE Notes...
  • Page 11 EL-SC-300 Notes...
  • Page 12 5919 Sea Otter Place, Carlsbad, CA, 92010 For more information on Elan Control Systems, visit: elancontrolsystems.com ©2022 Nortek Security & Control LLC. All rights reserved. Elan is a registered trademark of Nortek Security & Control LLC. P/N: 10024525 Rev-D...

This manual is also suitable for:

El-sc-300

Table of Contents