Advertisement
19.1.2. Tape Speed Adjustment (Deck 1/2)
1. Set the tape edit button to "NORMAL" position.
2. Insert the test tape (QZZCWAT) to DECK 2 and playback (FWD
side) the middle portion of it.
3. Adjust Motor VR (DECK 2) for the output value shown below.
Adjustment target: 2940 ~ 3060 Hz
(NORMAL speed)
4. After alignment, assure that the output frequency of the DECK 1
FWD are within ±60 Hz of the value of the output frequency of
DECK 2 FWD.
19.1.3. Bias Voltage Check
1. Set the unit "AUX" position.
2. Insert the Normal blank tape (QZZCRA) into DECK 2 and the unit
to "REC" mode (use "
3. Measure and make sure that the output is within the standard
PDF created with pdfFactory Pro trial version
Fig. 1
REC/STOP" key).
100
www.pdffactory.com
Advertisement
