Electrical Requirements; Gas Supply Requirements - Maytag MGT3800XW Installation Instructions Manual

eleCtriCal requirements

This washer/dryer is equipped with a power supply cord
n
having a 3-prong grounding plug.
To minimize possible shock hazard, the cord must be plugged
n
into a mating, 3-prong, grounding-type outlet, grounded in
accordance with local codes and ordinances. If a mating outlet
is not available, it is the personal responsibility and obligation
of the customer to have the properly grounded outlet installed
by a qualified electrician.
If codes permit and a separate ground wire is used, it is
n
recommended that a qualified electrician determine that
the ground path is adequate.
Do not ground to a gas pipe.
n
Check with a qualified electrician if you are not sure the
n
washer is properly grounded.
Do not have a fuse in the neutral or ground circuit.
n
120 Volt, 60 Hz, AC only, 15- or 20- amp fused electrical
n
supply is required. A time-delay fuse or circuit breaker is
recommended. It is also recommended that a separate
circuit serving only this washer/dryer be provided.

Gas suPPlY requirements

GAS TYPE
Natural Gas:
This washer/dryer is equipped for use with Natural gas. It is
design-certified by CSA International for LP (propane or butane)
gases with appropriate conversion.
Your washer/dryer must have the correct burner for the type of
n
gas in your home. Burner information is located on the rating
plate in the door well of your dryer. If this information does not
agree with the type of gas available, contact your dealer or call
the phone numbers referenced in the "Assistance or Service"
section of your Use and Care Guide.
LP Gas conversion:
IMPORTANT: Conversion must be made by a qualified
technician.
No attempt shall be made to convert the appliance from the gas
specified on the model/serial rating plate for use with a different
gas without consulting your gas company.
9