Kenwood KDC-BT665U Instruction Manual page 41

Troubleshooting
Symptom
Playback order is not as
intended.
Elapsed playing time is not
correct.
"READING" keeps flashing. • Do not use too many hierarchical levels and folders.
• Reload the disc or reattach the device (USB/iPod/
"UNSUPPORTED DEVICE" • Check whether the connected USB device is compatible
appears.
• Reattach the USB device.
"UNRESPONSIVE DEVICE"
appears.
"USB HUB IS NOT
SUPPORTED" appears.
• The source does not
change to "USB" when
you connect a USB device
while listening to another
source.
• "USB ERROR" appears.
The iPod/iPhone does not • Check the connection between this unit and iPod/iPhone.
turn on or does not work. • Disconnect and reset the iPod/iPhone using hard reset.
"LOADING" appears when
you enter search mode by
pressing
.
Remedy
Optical disc, the files are played in the order which they
were recorded.
USB device, the folders are played in the order of creation
(date and time). The files within each folder are played in
the order of the file name (alphabet).
This depends on the recording process earlier (disc/USB).
iPhone).
with this unit and ensure the file systems are in
supported formats. (Page 30, 31)
Make sure the USB device is not malfunction and reattach
the USB device.
This unit cannot support a USB device connected via a
USB hub.
The USB port is drawing more power than the design
limit. Turn the power off and unplug the USB device.
Then, turn on the power and reattach the USB device.
If this does not solve the problem, turn the power off and
on (or reset the unit) before replacing with another USB
device.
This unit is still preparing the iPod/iPhone music list. It
may take some time to load, try again later.
Symptom Remedy
"NO DISC" Insert a playable disc into the loading slot.
"TOC ERROR" Make sure the disc is clean and inserted properly.
"NA FILE" Make sure the media (disc/USB) contain supported audio
files. (Page 31)
"COPY PRO" A copy-protected file is played (disc/USB).
"NO DEVICE" Connect a device (USB/iPod/iPhone), and change the
source to USB or iPod USB again.
"NO MUSIC" Connect a device (USB/iPod/iPhone) that contains
playable audio files.
"iPod ERROR" • Reconnect the iPod.
• Reset the iPod.
• Press and hold B SRC to turn off the power. Turn the
power on again for error recovery.
"MEMORY FULL" You have reached the maximum storage limit of your
iPod/iPhone.
No Bluetooth device is • Search from the Bluetooth device again.
detected. • Reset the unit. (Page 3)
Bluetooth pairing cannot • Make sure you have entered the same PIN code to both
be made. the unit and Bluetooth device.
• Delete pairing information from both the unit and
the Bluetooth device, then perform pairing again.
(Page 13)
Echo or noise is heard during • Adjust the microphone unit's position. (Page 13)
a phone conversation. • Check the [ECHO CANCEL] setting. (Page 15)
Phone sound quality is poor. • Reduce the distance between the unit and the Bluetooth
device.
• Move the car to a place where you can get a better signal
reception.
33
ENGLISH