Table of Contents
Advertisement
46 °F (8 °C) operation
Pre-heating operation can be set for cold regions
where room temperature drops to below zero.
1
Push the [
MENU] button to display the
menu screen.
Push and hold the [
the [
] button at the same time to
4
display the "Field setting menu".
Push and hold the buttons for more than
4 seconds.
Push the [
] / [
3
"DN setting" on the "Field setting menu"
screen, then push the "
[
F2] button.
The fan and louver of the indoor unit
operate.
When the group control is used, the fan
and louver of the selected indoor unit
operate.
Specify CODE No. [D1]
Move the cursor to select "Code(DN)"
with the "
set "Code(DN)" with the [
button.
Move the cursor to select "Data" with
the "
" [
2
"Data" with the [
SET DATA
46 °F (8 °C) Operation setting
0000
0001
46 °F (8 °C) Operation setting
Push the [
CANCEL] button to return.
MENU] button and
] button to select
4
Set"
Set
" [ F1] button, then
1
] / [
]
3
4
F2] button, then set
] / [
] button.
3
4
None
(Factory default)
Central control system
Air conditioners at multiple locations can be
controlled individually for each refrigeration
system from a control room.
Central control is not available with the supplied
wireless remote controller. Use the optional wired
remote controller.
q Wiring for central control
The terminal block for central control wiring
(
and
) is the same as that for optional wired
U
U
3
4
remote controller. Connect the central control wire
to the terminals (
U
3
in the same way as the optional wired remote
controller. For details, refer to the installation
manual of the applicable central control system.
Terminal block
for control/wired
remote controller
wiring
Earth screw for
shield wire
Control wire
Cord clamp
‒ 38 ‒
Installation Manual
and
) on the terminal block
U
4
L1
L2
S
Wired
remote
controller
wire
EN
FR
ES
38-EN
Advertisement
Table of Contents
