Table of Contents
Advertisement
[Procedure example]
Manual address setup procedure
While the operation stops, change the setup.
(Stop the operation of the unit.)
1
Push the [
MENU] button to display the
menu screen.
Push and hold the [
the [
] button at the same time to
4
display the "Field setting menu".
Push and hold the buttons for more than
4 seconds.
Push the [
CANCEL] button to return.
Push the [
] / [
3
"DN setting" on the "Field setting menu"
screen, then push the "
[
F2] button.
The fan and louver of the indoor unit
operate.
When the group control is used, the fan
and louver of the selected indoor unit
operate.
Select the group-controlled function on
the menu screen, then push the
"
Set" [
Set
Push the "
select the unit to set.
The selected unit changes as follows each
time the button is pushed:
1-1
1-2
Push the "
Set
The setting display for the selected unit
appears.
(For a group control, No. of the firstly
displayed indoor unit becomes the header
unit.)
MENU] button and
] button to select
4
Set"
Set
F2] button.
unit" [
F1] button to
1-8
Set" [
F2] button.
‒ 36 ‒
2
The indoor UNIT No. in the group control
is displayed in order. Select the indoor unit
of which setup is changed.
In this time, the position of the indoor unit of
which setup is changed can be confirmed
because fan of the selected indoor unit
operate.
3
1. Specify CODE No. [12] with Move the cursor
to select "Code(DN)" with the "
[
F1] button, then set "Code(DN)" with the
[
] / [
] button.
3
4
(CODE No. [12]: Line address)
2. Change the line address from [3] to [2] with
Move the cursor to select "Data" with the
"
" [
F2] button, then set "Data"
2
with the [
] / [
3
3. Push the [
MENU] button to set the other
Code (DN) and Data. After "Continue?" is
displayed on the screen, push the
"
Yes" [
F1] button.
Yes
Indoor UNIT No. before setup change is displayed.
4
1. Specify CODE No. [13] with Move the cursor
to select "Code(DN)" with the "
[
F1] button, then set "Code(DN)" with the
[
] / [
] button.
3
4
(CODE No. [13]: Indoor address)
2. Change the Indoor address from [3] to [2] with
Move the cursor to select "Data" with the
"
" [
F2] button, then set "Data"
2
with the [
] / [
3
3. Push the [
MENU] button to set the other
Code (DN) and Data. After "Continue?" is
displayed on the screen, push the
"
Yes" [
F1] button.
Yes
Installation Manual
"
1
] button.
4
"
1
] button.
4
EN
FR
ES
36-EN
Advertisement
Table of Contents
