Page 1
OPERATING INSTRUCTIONS SAFE LOCK AXESSOR Electronic safe lock for WA safes...
Page 2
Many thanks! ❤️ Many thanks for choosing Waldis to give you the security you want. The safe you have decided to purchase is a product tested in compliance with the EN1143-1 standard. A Swiss quality product with security tested by the VdS (German Association of Indemnity Insurers).
Table of contents Overview ..........................1 Operating controls: WALDIS Eco and Business ............. 1 What the acoustic signals mean ................2 Description of the keys ....................2 Description of display messages ................2 Starting to use your safe ....................3 Operation ..........................
Overview The AXESSOR is installed as an optional lock in the WALDIS Eco and WALDIS Business series of models. Thanks to its display, it is easier and clearer to operate than the standard lock. Operating controls: WALDIS Eco and Business...
What the acoustic signals mean 1x short signal Input acknowledged 1x short, low signal Action denied 6x short signals The battery compartment was opened 6x short signals The lock is open The volume of the acoustic signals can be adjusted or turned off altogether. To do this, please contact your specialist dealer.
Starting to use your safe As soon as the safe has been delivered and correctly anchored, you can start operating the lock and using the safe. To do so, please keep to the following procedure: 1. Check that the rotary opening handle is in the 'closed' position.
input unit confirms that the door (lock) is open until the door is closed again. 7. Programme the new code as per section 3.3. Operation Opening the safe 1. First, press the rotary opening handle counterclockwise into the "closed" position to make sure that the lock bolt is relieved of pressure.
Locking the safe 1. Close the door (rotary opening handle in "open" position). 2. Turn the rotary opening handle counterclockwise into the "closed" position (lock closes automatically). 3. Gently press the rotary opening handle clockwise to check whether the lock – and therefore the safe –...
9. Press the Info key two or three times to exit the menu. 10. With the door open, move the rotary opening handle counterclockwise into the "closed" position (lock closes automatically). 11. Enter the newly programmed code and open the lock again by moving the rotary opening handle clockwise.
Pay attention to the polarity of the batteries! 3. Carefully pull the battery case downwards out of the input unit housing (six acoustic signals) and insert three 1.5 V AA alkaline batteries (LR6), or 1.5 V AA lithium batteries (FR6) into the battery case. 4.
Tamper block After 4 invalid code inputs, the keypad is blocked for 5 minutes. The remaining lockout time is shown on the display, and it cannot be bypassed. If two more incorrect codes are entered again after the lockout time has elapsed, the lockout time of 5 minutes will start again.