Safe lock with rotary knob, dual lock, electronic safe lock for wa safes and reinforced doors (19 pages)
Summary of Contents for WALDIS CAWI BLUECAM
Page 1
OPERATING INSTRUCTIONS SAFE LOCK CAWI BLUECAM Electronic door lock for WA safes Issue 08.2020...
Page 2
Thank you very much ❤ We would like to thank you for choosing Waldis when it comes to safety. When buying a safe, you have chosen a product tested according to EN1143-1. A Swiss quality product with VdS - tested security.
Table of contents Safe lock ........................ 1 1.1. General notes ....................1 1.1.1. Opening the lock ..................1 1.1.2. Open with the user code ................1 1.1.3. Open after 4 incorrect code entries ............2 1.1.4. Open with the master code ............... 2 1.1.5.
Safe lock 1.1. General notes For your safety, you should change these factory codes immediately Make all code changes only when the safe is open and the lock is in the closed position. 1.1.1. Opening the lock The user factory code is 1-2-3-4 The master factory code is 0-7-1-2-3-2 Procedure 1.
1.1.3. Open after 4 incorrect code entries After 4 incorrect code entries, the lock locks for 30 seconds. No entry is possible during this locking time After the blocking time has elapsed, the red LED goes out and a tone sounds several times Press the ON key 3 seconds Enter your 4-digit user code within 10 seconds...
1.1.5. Closing by the user Press the ON key 3 seconds Wait until the signal lights up permanently Turn the handle within 3 seconds. The lock is locked The closing procedure is the same for both users.
Code Programming 1.2. Code programming menu ATTENTION: All code reprogramming must be carried out with the door open! Edit from point to point, always within 10 seconds 1.2.1. Programming/changing the user code Press the ON key 10 seconds Enter the 4-digit user code Turn the handle within 3 seconds.
1.2.3. Changing the user code by the master code Press and hold the ON button until the LED lights up continuously Start entering the master code within 5 seconds 10 seconds Turn the handle within 3 seconds. The lock is open Press and hold the ON button until the LED turns solid green 5 seconds Enter the new valid user code within 5 seconds...
Power supply 3.1. General The lock is powered by a 9-volt alkaline block battery. If the red LED flashes after pressing the ON key, the battery is almost empty. Change the battery as soon as possible. If the LED flashes red five times after the ON key is pressed and is followed by a triple beep signal, the code can no longer be entered due to a lack of power.
Password 4.1. General basic rules 4.1.1. Avoid obvious passwords • No trivial values like 000000, 0815, 123456 • Do not use your own birthday, car license plate, phone number or name (your own, wife/husband, children, pets, company, place of residence, etc.) as password.