WALDIS CAWI 7215 Using Instructions

Using instructions digital code lock "CAWI 7215"
1.

TO OPEN THE LOCK

1.1. At the beginning turn the handle into closing position (level) by turning it counterclockwise.
The lock is in the „sleep mode" and has to be activated by pressing the button "C and 0"
1.2. Enter the correct code (factory code "1 2 3 4 5 6"), the green light flashes on once and a high-low
acoustical signal will be heard.
1.3. If the handle is not turned clockwise into the opening position (at the right angle) within
10 seconds the lock will be closed again.
1.4. Turn the handle into opening position (at the right angle) and wind the door up
1.5. Every key press will be affirmed by a „peep". Intermissions longer than 5 seconds will cancel the previous
entry. An incorrect entry can be cancelled by pressing the button C.
1.6. If an incorrect entry was made, the red light flashes on and there will be a high acoustical signal for 12
times. After 3 incorrect entries the lock will be blocked for 12 minutes. Every further incorrect entry will
extend the blocking time for 12 further minutes. During the blocking time the red light flashes on every 5
seconds. The ending of the blockage time will be announced by a low acoustical signal and the flashing
on of the green light.
1.7. After the blocking time the correct code must be entered and the lock can be opened.
2.

TO CLOSE THE LOCK

2.1. Close the door. Turn the handle into closing position (level) by turning it counter clockwise. The electronic
lock will close automatically.
WALDIS Tresore AG
Riedmattstrasse 12 ¦ CH-8153 Rümlang
H:\13 - Freigegebene Dokumente\Anleitungen\CAWI Schloss\CAWI 7215_E.doc
Oeffnungsdrehgriff
Handle
WA-60 - WA-150
¦ Tel. +41 (0)43 211 12 00 ¦
Oeffnungsdrehgriff
WA-40/50
MA-41 - MA-84
Fax +41 (0)43 211 12 12 ¦ www.tresore.ch ¦ info@tresore.ch