Table of Contents
Advertisement
Troubleshooting
Why won't the monitor turn on?
• Make sure that the monitor has been charged at least overnight before
first use. Press the reset button on the unit.
Message on monitor says to "See Guide for Troubleshooting".
• Make sure that the handheld unit is turned on and that the camera tube is
properly attached to the handheld unit.
The power light comes on but nothing shows on the screen?
• This could be due to weak batteries in the handheld. Replace batteries.
• Is the camera tube fully inserted to the handheld unit? When connecting
the camera tube to the handheld unit, make sure the keyed ends are
properly aligned. Once they are lined up, press in firmly and then finger
tighten the knob to hold the connector in place.
Why is my picture upside down?
• Simply press the image orientation button or move the camera tube to
properly orient the image.
What is the maximum depth the waterproof camera can be submerged?
• Approximately 12 feet - the camera extension limit of the unit. Camera
tube has a rating of IP67.
Why does the video look "Scrambled"?
• There are two video formats that the inspection camera can be set to:
NTSC format which is used in North America. The PAL format is used in
Europe and other overseas countries. Enter the menu selection and check
the video format to make sure the monitor is in NTSC format.
What format are the pictures and movies saved as?
• Still images are saved in a .jpg format. Movies are saved in a .avi format,
with video resolution at 640 x 480 pixels.
Video Output, will display live video or will it only display playback of
recorded video?
• When connected to a different monitor the unit will display live video as
well as picture and recorded playback.
Downloaded from
TROUBLESHOOTING
ManualsNet.com
8
search engine
Advertisement
Table of Contents
