Stihl FS 80 Instruction Manual page 7

English
Before Starting
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the instruction
manual:
– Use only an approved combination
of cutting tool, deflector, handle and
harness. All parts must be
assembled properly and securely.
– Slide control /stop switch must
move easily to STOP or 0.
– Smooth action of throttle trigger and
throttle trigger interlock (where
fitted) – throttle trigger must return
automatically to idle position.
– Check that spark plug boot is secure
– a loose boot may cause arcing
that could ignite combustible fumes
and cause a fire.
– Cutting tools and attachments:
Check for correct and secure
assembly and good condition.
– Check protective devices (e.g.
deflector for cutting tool, rider plate)
for damage or wear. Always replace
damaged parts. Do not operate your
machine with a damaged deflector
or worn rider plate (lettering and
arrows no longer legible).
6
– Never attempt to modify the controls
or safety devices
– Keep the handles dry and clean –
free from oil and pitch – for safe
control
– Adjust harness and handle(s) to suit
your height and reach. See chapter
on "Fitting the Harness – Balancing
the Brushcutter"
To reduce risk of personal injury, do not
operate your machine if it is damaged or
not properly assembled.
If you use a shoulder strap or full
harness: Practise removing and putting
down the machine as you would in an
emergency. To avoid damage, do not
throw the machine to the ground when
practising.
Starting the Engine
Start the engine at least 3 meters from
the fueling spot, outdoors only.
Place the unit on firm ground in an open
area. Make sure you have good balance
and footing. Hold the unit securely. The
cutting tool must be clear of the ground
and all other obstructions because it
may rotate when the engine starts.
Your brushcutter is a one-person unit. To
reduce the risk of injury from thrown
objects, do not allow other persons
within a radius of 15 meters of your own
position – even when starting.
To reduce the risk of
injury, avoid contact with
the cutting tool.
Do not drop start the
engine. The correct
starting procedure is
described in your
instruction manual. Note
that the cutting tool
continues to rotate for a short period
after you let go of the throttle trigger –
flywheel effect.
Check idle speed: The cutting tool must
not rotate when the engine is idling with
the throttle trigger released.
To reduce the risk of fire, keep hot
exhaust gases and hot muffler away
from easily combustible materials (e.g.
wood chips, bark, dry grass, fuel).
FS 80, FS 80 R, FS 85, FS 85 R