Stihl FS 80 Instruction Manual page 27

English
STIHL AutoCut
: Hold the rotating mowing head
above the ground – tap it on the
ground once – about 3 cm fresh line
is advanced.
The blade on the deflector trims surplus
line to the correct length – avoid tapping
head more than once at a time.
Line feed operates only if both lines
still have a minimum length of 2.5 cm.
All other mowing heads
Refer to instructions supplied with the
mowing head.
To reduce the risk of injury, always
shut off the engine before adjusting
the nylon line by hand.
Replacing nylon line or grass
cutting blades
Refer to instructions supplied with the
mowing head.
26
1
2
4
6
Mounting metal cutting tools
The skirt and line limiting blade
are not required for grass cutting
blades 230-2 (2), 230-4 (4), 230-8
(1), 250-40 Spezial (3) or the brush
knife (5) – see "Mounting the
Deflector".
Fit the appropriate limit stop for
circular saw blades 200 (6, 7) – see
"Mounting the Deflector".
3
5
7
: Lay your brushcutter on its back
with the cutting tool mounting face
pointing up:
Cutting edges of (2), (4) and (5) may
point in either direction.
Cutting edges of (1), (3), (6) and (7)
must point clockwise.
Direction of rotation is marked by
arrow on inside of cutting head
deflector or limit stop.
FS 80, FS 80 R, FS 85, FS 85 R
14
13
11
10
8
12
9