Stihl FS 80 Instruction Manual page 18

7
7
Mounting the Handlebar
: Place the handlebar (7) in the lower
clamp (1) so that distance A is no
more than 15 cm (6 in).
: Place the upper clamp in position
and hold both clamps together.
: Push the wing screw through the
two clamps as far as stop – hold all
parts together and secure them.
FS 80, FS 80 R, FS 85, FS 85 R
A
1
A
1
: Place the secured assembly on the
handle support (8) with the wing
screw at the engine side.
: Push the wing screw into the handle
support as far as stop and then
screw it down – but do not finally
tighten yet.
: Line up the handlebar at a right
angle to the drive tube – check
dimension A again.
: Tighten down the wing screw firmly.
8
Mounting the Control Handle
: Loosen the screw (9) and remove it.
The nut (10) remains in the control
handle (11).
: Push the control handle – throttle
trigger (12) must point towards the
gearbox – onto the handlebar (7) so
that the holes (13) line up.
: Insert screw with washer and
tighten down firmly.
English
17