Stihl FS 80 Instruction Manual page 19

English
14
15
15
14
15
Fitting the Throttle Cable
Do not kink the throttle cable or lay
it in tight radii – make sure the
throttle trigger moves freely.
: Push the throttle cable (14) into the
retainers (15).
Throttle Cable Adjustment*
On control handles with slide*:
: Go to chapter on "Adjusting the
Throttle Cable".
* see "Guide to Using this Manual"
18
7
3
Swiveling the Handlebar
Transport position:
: Release the wing screw (3) and
unscrew it until the handlebar (7)
can be turned clockwise.
: Turn the handlebar 90° and then
then swing the handles down.
: Tighten down the wing screw firmly.
Working position:
: Reverse the sequence described
above to swing the handles up
and turn the handlebar counter-
clockwise.
Version with Fixed Handle
Support
6
4
90°
2
Mounting the Handlebar
: Mount the handlebar (1) on the drive
tube (2) about 40 cm/16 in (A)
forward of the engine.
: Place the clamp (3) and the handle
support (4) on the drive tube.
: Position the handlebar (1) on the
handle support – the rubber grip
must be on the left (viewed from the
engine).
FS 80, FS 80 R, FS 85, FS 85 R
6
5
1
3
A