Table of Contents
Advertisement
Removing and replacing the D6020 disk drive drawer
Removing the D6020 disk drive drawer
Procedure
1.
Power down the D6020 (see Powering down the D6020).
2.
Disconnect all cables.
3.
Remove all power supplies (see Removing and replacing the D6020 power supply).
4.
Remove all fan modules (see Removing and replacing the D6020 fan).
5.
Remove the disk drives (see Removing the hard drive or hard drive blank).
CAUTION: To avoid data loss, be sure that the drives are labeled and returned to the same bays from which
they were removed.
6.
Make sure that the disk drive drawer is closed completely.
7.
Remove all I/O modules (see Removing and replacing the hot-pluggable I/O module).
8.
Pull down the handle on the front of the drawer, but do not extend the drawer.
9.
Push up and hold the two release mechanisms on the I/O bays, and then move the drawer forward about 15 cm (6
in).
10. Remove the power block (see Removing and replacing the D6020 power block).
11. Extend the disk drive drawer until it clicks.
Removal and replacement procedures
21
Advertisement
Table of Contents
