Quick Start Up - PROEL KDC3900 Series Manual

3. Quick start up

The following are the basic steps for basic configuration of KDC3900 system. Programming is
done via two programming menu:
•
Graphic
•
A-
– borrowed from KDC1905
The operation should start from the graphic menu:
"graphical"
a) Entering the
0 -> -> 240360 -> installer code (default '0000').
2) Keyboard security:
a) Enter the "Settings" submenu using buttons
select "Installer code"
b) The cassette will display the current code. Delete the old code with button , enter a new
installer code, confirm with button
The code can also be changed from the old type programming menu in submenu A-7 (see
chapter 10.7) – this is the only option for BM0900
3) Entering residents' data (KDC39XX keyboard only):
a) Enter in the "Editing the residents list"
b) Press , "Edit entry" or "New entry"
c) Fill in the "Premises number" field – this is a number entered by the user from keyboard
d) The field "Destination number" is used to redirect a number entered from keyboard (e.g.
from 100a to 250)
e) In the 'Lock code' field you can overwrite standard code, which is generated by a code
table (attached to the device in paper form)
f) IDs are recorded via item "RFID" – press
closer to the keyboard digit. All of them will be added to the edited entry
g) In the "Surname" field you can enter a text, which will be displayed on the residents list
available from the main screen. It is also possible to hide the entry by entering the value
1 in the "Hidden" field.
4) Configuration of display and volume:
a) Go to the "Adjustments" tab
b) Using buttons 1-5 it is possible to change the adjusted parameter, the button 0 changes
adjustment step
•
1 – volume of beeper from the button
•
2 – volume of ringing tone on the keyboard
•
3 – contrast
•
4 – backlight brightness in active state
•
5 – backlight brightness at idle (lifting above 50% is not recommended)
c) Locking configuration – if other than standard 12V locking is used. The configuration is
described in chapter 11.5.2
– borrowed from KDC3100 (available only for KDC39XX keyboards)
programming: press and hold down while idle
and , by confirming with button , then
, enter a new code again and confirm with button
, select "Add RFID" and then bring next IDs
6