CDN SD0204 Manual

FOR PRECISE & GENERAL WEIGHING
• Precise to 0.01 oz/0.1 g
• NSF Certified
®
• Small profile
• Tare function
• Hold mode
• Field calibration
• Removable stainless steel platform
• Selectable units
• Overload indication
• Battery status indication
• On/off button
• Auto-off after 2 minutes; disabled when
the AC adapter is used
• Food-safe ABS plastic with BioCote
• Platform Size:
5.35 W x 5.35 L (in)/13.6 W x 13.6 L (cm), removable
• Resolution: 0.01 oz, 0.1 g
• Product Dimensions:
5.90 W x 1.75 H x 7.87 D (inches)/
15.0 W x 4.45 H x 20.0 D (cm)
• AC Adapter:
100-240VAC 50/60Hz input, 9V DC (500mA) output,
included
• Two AAA alkaline batteries (WERCSmart) included
Note: Clean the scale before each use.
Important: DO NOT IMMERSE IN LIQUID.
®
Tel 800 338-5594 Fax 800 879-2364 Web CDNmeasurement.com
DIGITAL HIGH PRECISION SCALE
2 POUNDS/1 KILOGRAM by pounds:ounces and kilograms.grams
Note:
In the following instructions, names of the control
buttons are shown in CAPS. Function information that
appears on the display is shown in BOLD CAPS.

BATTERY INSTALLATION

Replace battery when LCD becomes dim.
appears on the display for 2 seconds before turning
off when the batteries need to be replaced.
1. Power off the unit before installing the batteries.
2. Remove battery cover on the bottom by pressing
the latch toward the battery cover and lifting up.
3. Install two AAA alkaline batteries observing
polarity shown in compartment.
4. Replace the battery cover until it clicks shut.

POWER ADAPTER

Before using the external power adapter, make sure
that the printed voltage complies with the local
voltage.
Note: Use only an original CDN power adapter (AD-AC3302). The
use of another adapter is subject to approval by CDN.
1. Insert the adapter plug into the jack in the rear of
the scale.
2. To turn the scale on, press the ON/OFF button
as described in Section A: On/Off. The scale will
remain on until turned off.
Note: When the power adapter is plugged in, the auto-off
feature is disabled.

OPERATING INSTRUCTIONS

Place the scale gently on a hard and flat surface and
make sure it is steady before use to obtain accurate
measurements.

A. On/Off

1. Press the ON/OFF button to turn on. The display
flashes ––– and then returns to zero.
2. Press and hold the ON/OFF button for
2 seconds to turn off.

B. Auto Off

The scale automatically turns off after 2 minutes
of inactivity when the AC adapter is not plugged in.
Note: Auto-off is disabled when the AC adapter is used.
Model: SD0204
bAtt