CDN SD0602 Quick Start Manual

FOR GENERAL WEIGHING
• Selectable units
• Tare function
• Overload indication
• Low battery indication
• On/off button
• Auto-off after 5 minutes
• Platform Size:
5.1"/13.0 cm diameter
• FDA compliant HIPS plastic housing
• Resolution: 0.001 lb, 1 g, 0.1 oz, 1 ml
• Product Dimensions:
5.5 W x 1.18 H x 6.8 D (in)/
14.0 W x 3.0 H x 17.3 D (cm)
• Hang hole
• One CR2032 lithium battery (WERCSmart) included
Note: Clean the scale before each use.
Important: DO NOT IMMERSE IN LIQUID.
DIGITAL PORTION CONTROL SCALE, 6 LB
6 POUNDS/3 KILOGRAMS/105 OUNCES/3 LITERS by pounds, ounces, grams and milliliters
Tel 800 338-5594 Fax 800 879-2364 Web CDNmeasurement.com
Note:
In the following instructions, names of the control
buttons are shown in CAPS. Function information that
appears on the display is shown in BOLD CAPS.
BATTERY INSTALLATION
Replace battery when LCD becomes dim. LO
appears on the display when battery status is low
and needs to be replaced.
1. Power off the unit before installing the battery.
2. Remove battery cover on the back by pressing the
latch in and lifting up.
3. Install one CR2032 lithium battery with positive (+)
side up.
4. Replace the battery cover until it clicks shut.
OPERATING INSTRUCTIONS
Place the scale gently on a hard and flat surface and
make sure it is steady before use to obtain accurate
measurements.
A. On/Off
1. Press the ON/TARE button to turn on.
2. Press the ON/TARE button for 2 seconds
to turn off.
B. Auto Off
The scale automatically turns off after 5 minutes
of inactivity.
C. Unit Selection
Press the UNIT button to select the desired unit.
The display cycles through oz, lb,
D. Weighing Mode
Place an item on the scale platform. The weight of
the item appears on the display within 0.5 second
after the item is stable.
Note: The minimum measurable weight is 0.011 lb/0.2 oz/5 g/5
ml.
E. Tare
The tare function resets the scale display to zero
in order to measure only the weight of an item.
It is frequently used to subtract the weight of
containers.
1. When the scale is on, place a container on
the platform.
2. Press the ON/TARE button to reset the display
to zero. TARE appears on the left
0.0
of the display and
the main area of the display.
Model: SD0602
ml and g.
appears in