CDN SD1106 Operating Instructions Manual

Features
• Tare function
• 999 food codes from the USDA National Nutrient
Database
• Nutritional data: calories, sodium, protein, fat,
carbohyrates, cholesterol and fiber
• Tempered glass
• Selectable units
• Overload indication
• Battery status indication
• On/off button
• Auto-off after 60 seconds
• Batteries and instructions included
Note: In the following instructions, names of the control
buttons are shown in CAPS. Function information that
appears on the display is shown in BOLD CAPS.

Battery Installation

Replace battery when LCD becomes dim. Lo appears
on the display when battery status is low and needs to
be replaced.
1. Power off the unit before installing the battery.
2. Remove battery cover on the back by pressing
the latch in and lifting up.
3. Install four 1.5V AAA IEC LR03 Alkaline batteries
observing polarity shown in compartment.
4. Replace the battery cover until it clicks shut.
Digital Nutrition Scale
11 pounds/5 kilograms/176 ounces/5 liters
by ounces, fluid ounces, grams and milliliters

Operating Instructions

Place the scale gently on a hard and flat surface and
make sure it is steady before use to obtain accurate
measurements.
A. On/Off
1. Press the ON button to turn on. The display
flashes all segments and then returns to zero.
WT appears in the upper left corner of the
display to indicate that the scale is ready and in
weighing mode.
2. Press the OFF button to turn off.
B. Auto Off
The scale automatically turns off after 60 seconds
of inactivity.
C. Unit Selection
Press the UNIT button to to select the desired unit.
The display cycles through oz, fl oz, ml and g.
D. Tare
The tare function resets the scale display to zero
in order to measure only the weight of an item. It is
frequently used to subtract the weight of containers.
1. When the scale is on, place a container on
the platform.
2. Press the TARE button to reset the display to zero.
3. Place the item into the container or directly on
the scale platform. The weight of only the last
item added will appear on the display.
4. Continue to repeat steps 2 and 3 to measure the
respective weights of additional items.
5. To clear the tare, remove all items from the
platform and press the TARE button.
E. Nutritional Data
This scale is preprogrammed with nutritional data
for calories, sodium, protein, fat and carbohydrates
from the USDA National Nutrient Database. There
are 999 unique food codes that are listed in this
manual, starting on page 3.
1. When in weighing mode, place a food item on the
platform and press the C/MC button to reset the
food code to 000.
2. Locate the appropriate food code from the list on
page 3.
3. Enter the desired food code by pressing the
numbers at the lower left of the scale. The weight
and the nutritional data appear on the display.
Model: SD1106