Installing Pointsec Pc In An Ibm Rru Environment; Running Using Precheck.txt; Running Installrru.msi After Installation - Check Point Pointsec PC Installation Manual

Installing Pointsec PC in an IBM RRU
Environment

Running Using precheck.txt

Running InstallRRU.msi after Installation

Table 2-3
Entry
EncryptionProgress:
To install Pointsec PC in an IBM Rapid Restore Ultra (RRU) environment,
you must run the installation package, InstallRRU.msi .
You can run InstallRRU.msi by specifying it in precheck.txt before
installation or by manually running it after installing Pointsec PC as
normal.
For more information on precheck.txt , see Chapter 1, Review precheck.txt
on page 10.
To run InstallRRU.msi using precheck.txt:
1. Open precheck.txt and locate the RunAfter setting. Set RunAfter= to
the path to InstallRRU.msi. We recommend that you use a path of
max 8 characters, without spaces or special characters, for example
C:\P4PCINST\ Save the changes to precheck.txt and close the file.
.
Note - If you want to do a silent installation, msiexec.exe can be used.
The full search path must then be supplied. The normal location for
msiexec.exe is in the system32 directory, for example:
C:\Windows\System32\msiexec.exe /i C:Ppointsec\InstallRRU.msi
/q
2. Install Pointsec PC as normal, reboot the computer and authenticate.
Once the computer has been rebooted, InstallRRU.msi is executed.
Note - If there is an anti-virus application installed, ensure that
InstallRRU.msi is not stopped from running. If InstallRRU.msi is
stopped by mistake, you should be able to run it manually afterwards.
3. Press . Pointsec PC is now installed with IBM RRU.
"OK" DONE
To run InstallRRU.msi after installation:

Installing Pointsec PC in an IBM RRU Environment

Value Explanation
0 Stable
1 Encrypting
2 Decrypting
Chapter 2 Installing Pointsec PC for Administrators 37