Check Point Pointsec PC Installation Manual page 19

Table 1-1 General Settings
Setting
HidInf=
Drivers=
Description
Together with Drivers= , this setting is used to deploy the HID
driver, found under /modules/hid . For example:
Drivers=HID\hptc1100.bin
HidInf=HID\hptc1100.inf
The HID driver enables the pen on tablet PCs.
See the current Release Notes for available drivers.
Note: If you have installed a Wacom driver on a computer that
does not have Wacom hardware installed, this can cause
hanging during preboot. To avoid this, hold both SHIFT keys
down while the progress bar is visible during the loading of
Pointsec preboot. A new menu selection, HID drivers, will be
displayed, allowing you to disable the Wacom driver(s).
Note: You can also deploy HID drivers after installation using
pscontrol.exe . For example:
C:\>pscontrol register-hid hptc1100.inf
C:\>pscontrol install-driver hptc1100.bin
The value of this setting specifies the preboot smart card
drivers that will be installed together with the Pointsec PC
system. These drivers enable communication between a smart
card and Pointsec PC prior to the start of Windows.
The specified value for this setting must be a
semicolon-separated list of file names with no paths specified
and no blanks. For example:
Drivers=msc_p11.bin;prd_ccid.bin
Available drivers are located in the Modules folder.
With the help of this facility, it is possible to use a smart card
to log on at initial authentication.
See the description of HidInf= , above, for information on
using Drivers= to deploy HID drivers.
Chapter 1 Before You Install Pointsec PC
Review precheck.txt
13