Table of Contents
Advertisement
Installation
STEP 4 Position the drain hose
16
English
Untitled-1 16
General type
1. Press and hold down the joint ring, and insert it into
the drain hose.
2. Insert the drain hose into the drain outlet. Make sure
to connect them firmly using the joint ring. The drain
hose is extensible. Adjust the length of the drain hose
as needed.
Pump type (Applicable models only)
A
1. Open the hose cap (A), and insert the drain hose.
Tighten the drain hose using the joint ring.
NOTE
• The position (side or rear) of the drain outlet depends
on the model.
• Availability of the hose cap depends on the model.
2021-06-09
11:33:18
Advertisement
Table of Contents
