Removal And Replacement Procedures-Small Form Factor (Sff) Chassis; Preparation For Disassembly - HP Compaq dc5700 MT Reference Manual

Removal and Replacement Procedures—
Adherence to the procedures and precautions described in this chapter is essential for proper
service. After completing all necessary removal and replacement procedures, run the Diagnostics
utility to verify that all components operate properly.
✎
Not all features listed in this guide are available on all computers.
7.1

Preparation for Disassembly

See Chapter 5, "Identifying the Chassis, Routine Care, and Disassembly
safety procedures.
1. Close any open software applications.
2. Exit the operating system.
3. Remove/disengage any security devices that prohibit opening the computer.
4. Remove any diskette or compact disc from the computer.
5. Turn off the computer and any peripheral devices that are connected to it.
Ä CAUTION: Turn off the computer before disconnecting any cables.
CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as
Ä
the system is plugged into an active AC outlet. In some systems the cooling fan is on even when the
computer is in the "Standby," or "Suspend" modes. The power cord should always be disconnected
before servicing a unit.
6. Disconnect the power cord from the electrical outlet and then from the computer.
7. Disconnect all peripheral device cables from the computer.
✎
During disassembly, label each cable as you remove it, noting its position and routing.
Ä CAUTION: The screws used in the computer are of different thread sizes and lengths; using the wrong
screw in an application may damage the unit.
Service Reference Guide, dc5700
Small Form Factor (SFF) Chassis
437804-001
7
Preparation,"for initial
7–1