HP Compaq d330 DT Troubleshooting Manual page 64

Numeric Codes and Text Messages (Continued)
Code/Message
602-Diskette Boot
Record Error
605-Diskette Drive
Type Error
610-External
Storage Device
Failure
611-Primary Floppy
Port Address
Assignment Conflict
612-Secondary
Floppy Port Address
Assignment Conflict
660-Display cache
is detected
unreliable
912-Computer
Cover Has Been
Removed Since Last
System Startup
914-Hood Lock Coil
is not Connected
Troubleshooting Guide
Probable Cause
Diskette in Drive A not
bootable.
Mismatch in drive type.
External tape drive not
connected.
Configuration error.
Configuration error.
Integrated graphics
controller display cache
is not working properly
and will be disabled.
Computer cover was
removed since last system
startup.
Smart Cover Lock
mechanism is missing or
not connected.
www.hp.com
Recommended Action
Replace the diskette.
1. Run Computer Setup.
2. Disconnect any other diskette
controller devices (tape drives).
3. Clear CMOS. (See
"Password Security and Resetting
CMOS.")
Reinstall tape drive or press F1 and allow
system to reconfigure without the drive.
Run Computer Setup.
1. Run Computer Setup.
2. Remove expansion cards.
3. Clear CMOS. (See
"Password Security and Resetting
CMOS.")
Replace system board if minimal graphics
degrading is an issue.
No action required.
1. Reconnect or replace hood locking
mechanism.
2. Reseat or replace hood locking
mechanism cable.
POST Error Messages
Appendix B,
Appendix B,
A–7