HP Brio 8200 Online Manual page 60

3 Upgrading and Adding Accessories
Adding Accessories
7 Turn on the display and then turn on the computer. In Windows, check that the new drive has been recognized: double-
click the My Computer icon on the desktop and check that the new drive is there.
Before you can see (in Windows) and use a completely new hard disk drive, you need to set up partitions and then
format the drive. To do this, restart your computer in MS-DOS mode, run fdisk to set up the partitions, restart the
computer, and then format the new drive from within Windows.
Troubleshooting
If the new drive is not recognized, you may need to run the Setup program: restart the computer and press when
Press <F2> to enter SETUP is displayed at the bottom of the screen. If you have any doubts about using the
Setup program, contact your reseller for help.
If the new drive is still not recognized, check that you have correctly followed the installation procedure described
above.
If there are any errors reported during the computer's startup routine, press to view the error(s) and take any
necessary action.
If you cannot start your computer properly, remove the drive and try starting your computer again. If the computer
now starts without any problems, there may be a problem with the new drive.
If you experience any other problems as a result of the upgrade, and your computer is supplied with the HP Brio Center,
refer to the support tools for further assistance.
60