HP Brio 8200 Online Manual page 58

If you install a hard disk drive and connect it to the cable that the
Note
must be connected to the Master connector in the cable from the system board, not the Slave connector. If you have
a CD-ROM drive currently connected to the Master connector, you must reconnect the CD-ROM drive to the Slave
connector of the cable, and then attach the new hard disk drive to the Master connector.
There are two different types of power connectors:
Power Connectors for Hard
Disk Drives, Tape Drives,
5.25-inch Floppy Disk Drives,
CD-ROM Drives, Zip Drives,
and 3.5-inch Floppy Disk
Drives
Some of the power connectors will be already connected to devices.
If you install a device that requires a different connector, the connector converter should be supplied with the device.
3 Upgrading and Adding Accessories
CD-ROM drive is connected to, the hard disk drive
Adding Accessories
Power Connector for 3.5-
inch Floppy Disk Drive
58