HP Brio 8200 Online Manual page 40

Installing Main Memory Modules
1 Remove the computer's cover (refer to
2 On a table top turn the computer onto its side, with the system board closest to the surface of the table.
Static electricity can damage electronic components. Turn off all equipment. Don't let your clothes touch the
Caution
accessory. To equalize the static electricity, rest the accessory bag on top of the computer while you are removing
the accessory from the bag. Handle the accessory as little as possible and with care.
3 Handle the memory module by its edges. Slide the memory module into the connector at 90
module will only fit into the socket one way round).
4 Firmly press the memory module completely into the connector until the retaining clips click into position.
5 If you need to remove a memory module, perhaps because you are replacing an existing module, refer to
Memory Module" below.
"Removing the Cover" on page
System Board
Retaining Clips
3 Upgrading and Adding Accessories
37).
o
to the system board (the
Ž

Upgrading Hardware
"Removing a
40