HP Brio 8200 Online Manual page 46

Installing a Processor Upgrade
Removing the Old
1 Remove the computer's cover (refer to
Processor
2 On a table top turn the computer onto its side, with the system board closest to the surface of the table.
3 If the heatsink is not directly attached to the processor, unclip the heatsink.
4 Unlock the socket and lift out the old processor.
Installing the New
1 Position the processor over the socket, with the processor's corner marker facing the socket's corner marker.
Processor
Locating the markers:
•
on the processor—a dot or notch ("broken" corner)
•
on the processor socket—no pin hole in the corner.
2 Gently place the processor in the socket.
3 Lower the socket's lever to lock the processor into position.
4 Replace the heatsink and fasten the clip (if the heatsink is not directly attached to the processor).
"Removing the Cover" on page
Heatsink
37).
Processor
If any thermal interface material, such as
aluminum foil or silicone, is supplied with
the heatsink or the processor, place it
carefully on the top of the processor before
installing the heatsink.
3 Upgrading and Adding Accessories
Upgrading Hardware
46