Page 4
Assemble EMV Arm to Display Bracket. Add Add (2) screws to EMV Mount Plate from bag “P” (2) screws from bag “P” at right most at position 1, 2,3 or 4. Leave ~3mm (1/8”) gap (for position “A” to secure EMV Arm to Display EMV Arm).
Page 5
Cover Plate Attach EMV Cover Plate and screws. For Square Terminal, skip to step 7. Route EMV terminal Remove and save EMV Cover Plate and screws. cable and tie-wrap. Add (3) screws for mounting EMV terminal: - Use bag “G” and holes labeled “1” for Ingenico iSC250 - Use bag ”H”...
Page 6
Cover Plate From Bag “Q” Base Plate From Bag “H” For Square Terminal, skip to step 7. Attach Square Terminal using (1) screw from bag “Q”, threading screw into hole on bottom of Square Terminal. Remove and discard EMV Cover Plate and M4 screws. Assemble (3) screws from bag “H”...
Page 8
Remove plastic cover from right edge of display. Add Edge Bracket using (2) screws from bag “C”. Use Edge Bracket “15 A” for Android 15” Use Edge Bracket “22 A” for Android 22” 2.0/3.0 Use Edge Bracket “22 A4” for Android 22” 4.0 Use Edge Bracket “15 W”...
Page 9
Learn more about Elo at EloTouch.com. Americas Europe (EMEA) Asia Pacific Tel +1 408 597 8000 Tel +32 16 930 136 Tel +86 (21) 3329 1385 EloSales.NA@elotouch.com EMEA.sales@elotouch.com EloAsia@elotouch.com The information in this document is subject to change without notice. Elo Touch Solutions, Inc. and its Affiliates (collectively “Elo”) makes no representations or warranties with respect to the contents herein, and specifically disclaims any implied warranties of merchantability or fitness for a particular purpose.